How to Extend the Service Life of Color Steel Roof Tile Roll Forming Machine?

 

In the operation process of the color steel roof tile roll forming machine, some faults often occur, which not only affects the normal production, but also costs a lot of manpower and material resources for troubleshooting. More importantly, if the color steel roof tile roll forming machine often fails, it will have a significant impact on the performance of the color steel roof tile roll forming machine in the future. Therefore, Jinggong, the color steel roof tile roll forming machine manufacturer, suggests that you should pay attention to its maintenance during use, so as to effectively extend the service life of the color steel tile forming machine. Pay attention to the following points:

 

1. Do not operate the equipment above the closing height. For example, if the distance from the bottom of the upper sliding box to each working surface is 290mm, it is required that the height behind the upper and lower dies plus the thickness of the upper and lower base plates plus the thickness of the tile blank shall not exceed 290mm. When manufacturing the mould, it should be designed according to the requirements to avoid machine failure.

 

2. Make sure to clean the appearance of the color steel roof tile roll forming machine. The stamping process of the upper die of the color steel tile forming machine is as follows: the input shaft is driven by the motor through the belt pulley, the upper shaft is driven by the big and small gears, the sliding seat with the upper die is driven upward and slides downward through the cam mechanism, so as to achieve the effect of tile pressing.

 

3. The rotation position of the worktable is mainly achieved by the indexing and positioning of the gear set installed at the end of the upper shaft, the driving speed pin gear, and the moving Geneva installed on the hexagonal runner shaft.

 

At both ends of the upper shaft, there is a reset cam conjugated with the pressing cam installed on the same shaft, and the positioning of the lower die in the working position is realized through the positioning rod and positioning plate. On the left and right sides of the housing, a lubrication pump is installed.

 

When the machine is working, the oil pipe delivers lubricating oil to the friction moving parts. If you know the structure, performance and operation regulations of the machine, you can start the equipment, otherwise, you should not operate it.

 

4. Make sure to carefully check the height of lubricating oil between the sliding box and the body on both sides. The color steel roof tile roll forming machine should be cleaned regularly, and there must be no mud or water drops.